My truck on an All-Wheel-Drive Dyno

Five of us NWSTP guys took our trucks to a local all-wheel-drive dyno on April 14, 2001 to see what kind of numbers our trucks put out. My best at the flywheel was 345.1 hp @ 4200 RPM and 441.9 lbs-ft of torque @ 3950 rpm. These were obtained on a motor with L35 heads, 2.02/1.60 valves, TRW forged pistons, Eagle rods, Crane cam, 1.6 ratio rockers, stock crank, stock chip, stock turbo, stock governor, stock injectors, and stock air intake. My fuel pressure was at 47 psi, and my knock retard was at 0.0 degree throughout the entire run.

I only wanted to do baseline run this time. I will do some more dyno runs with the Ultimate Chip, the 5200 RPM governor, and the Kenne Bell cold air kit in the near future.

Typhoon strapped down and ready to roll

All four wheels spinning

Dyno results

See other NWSTP trucks on AWD dyno

Home

richardl@whitetyphoon.com